Model SkyScan 31269

I recently inherited this clock. I need manual on how to set it up. Thank you

 

Model 31269

PROGRAM MENU:

DAYLIGHT SAVING TIME: Press and hold the YEAR/SEC/ALM/DST/C/F button for 5 seconds to select DST on or off. The letters DST will appear above the seconds when DST is ON.

FAHRENHEIT/CELSIUS: Press and release the YEAR/SEC/ALM/DST/C/F button to switch from Fahrenheit to Celsius.

12/24-HOUR MODE: Press and release the DATE/MIN/12/24 button to select 12-hour or 24-hour time. 24Hr will appear in front of the hour when in 24-hour mode.

TIME ZONE: Press and hold the MODE button until the map icon is flashing. Press and release the MONTH/HR/WAVE/ZONE button to select the correct Time Zone. Press and release the MODE button.

CALENDAR SETTINGS: The Calendar settings will flash.       

  • YEAR: Press and release the YEAR/SEC/ALM/DST/C/F to select the correct Year.
  • MONTH: Press and release the MONTH/HR/WAVE/ZONE button to select the correct Month.
  • DATE: Press and release the DATE/MIN/12/24 to select the correct Date.

TIME SETTINGS: After the calendar settings, press and release the MODE button to enter the Time settings.

  • HOUR: Press and release the MONTH/HR/WAVE/ZONE button to select the correct HOUR.
  • MINUTES: Press and release the DATE/MIN/12/24 to select the correct Minutes.
  • SECONDS: Press and release the YEAR/SEC/ALM/DST/C/F to reset the Seconds to zero. Press and release the MODE button to confirm the settings.

ALARM SET: From a normal display, press and release the MODE button to enter Alarm mode (the letters AL will appear between the hour and the minutes).

  • HOUR: Press and release the MONTH/HR/WAVE/ZONE button to select the correct HOUR.
  • MINUTES: Press and release the DATE/MIN/12/24 to select the correct Minutes.
  • ALARM ON/OFF: Press and release the YEAR/SEC/ALM/DST/C/F to select the Alarm ON/OFF. There will be a bell icon that appears above the colon to indicate the Alarm in ON.
  • SNOOZE ON/OFF: Press and release the YEAR/SEC/ALM/DST/C/F to select the Snooze ON/OFF. There will be Zz icon that appears below the colon to indicate the Snooze function in ON. Press and release the MODE button to confirm the settings.

SNOOZE FUNCTION: When the alarm sounds press the SNOOZE/LIGHT button to activate the snooze function for 5 minutes.

BACKLIGHT: Press the SNOOZE/LIGHT button to activate the backlight for 5 seconds.

PROJECTION: The AC power cord must be plugged for constant projection.

  • BATTERY OPERATION:  When operating on batteries only the Projection will show for 5 seconds when the SNOOZE/LIGHT button is pressed if the PROJECTION button is turned on.
  • PROJECTION ARM: The Projection Arm will rotate 180 degrees to allow projection on the wall or ceiling.
  • FOCUS: Use the FOCUS button on the back to the projection arm to adjust the clarity of the projection.
  • ROTATE: Use the ROTATE button on the back to change the orientation of the projection. This corrects the upside-down look.

WWVB: The clock will search for a WWVB signal for up to 10 minutes when powered up. During this time there is limited button function.  To bypass WWVB and manually set the clock, press and release the MONTH/HR/WAVE/ZONE button. You can restart the WWVB search at any time by holding the MONTH/HR/WAVE/ZONE button for 5 seconds.